Neptune Liquid Level Sensor - 35 Inch
Neptune Liquid Level Sensor - 35 Inch
The Neptune LLS Sensors for your Apex controller allow for the measurement of water depth in inches or centimeters.
The Liquid Level Sensor is available in four different sizes- 4", 15" 23" and 35" with each sensor having a special place in helping understand the water level in the sump, aquarium, reservoirs, and other liquid-holding containers.
No longer do you need to physically look to see how much water level is above or below a specific point, but now simply open the Apex Fusion App and observe.
How the LLS from Neptune works
The LLS sensor can connect to any available FMM port in your Apex System. Liquid will enter the plastic envelope around the thin material of the sensor. Once the liquid is in contact with the sensor material the LLS uses a patented resistive sensing technology to accurately and reliably measure the liquid level in a container.
Included with each LLS sensor is a clip that allows for the mounting of the sensor to the side of the sump, aquarium or container. You can also mount the LLS sensor to a baffle inside the sump.
Once calibrated the LLS is accurate to about two-tenths of an inch.
Liquid Level Sensor- 35" Applications
The largest of the LLS sensors is the 35" sensor. This sensor is to be used for large reservoirs that are often utilized for saltwater reservoirs for manual and automatic water changes.
Application Notes for the LSS
The components in the head of the LLS are fully encapsulated in epoxy, but the LLS is not intended to be fully submerged. Care should be taken when selecting the proper length of LLS and installing it to ensure that the water level never exceeds the uppermost graduation mark.
